#include <linux/timer.h>
#include <linux/acpi_pmtmr.h>
#include <linux/cpufreq.h>
-#include <linux/dmi.h>
#include <linux/delay.h>
#include <linux/clocksource.h>
#include <linux/percpu.h>
static inline int pit_expect_msb(unsigned char val, u64 *tscp, unsigned long *deltap)
{
int count;
- u64 tsc = 0;
+ u64 tsc = 0, prev_tsc = 0;
for (count = 0; count < 50000; count++) {
if (!pit_verify_msb(val))
break;
+ prev_tsc = tsc;
tsc = get_cycles();
}
- *deltap = get_cycles() - tsc;
+ *deltap = get_cycles() - prev_tsc;
*tscp = tsc;
/*
* How many MSB values do we want to see? We aim for
* a maximum error rate of 500ppm (in practice the
* real error is much smaller), but refuse to spend
- * more than 25ms on it.
+ * more than 50ms on it.
*/
-#define MAX_QUICK_PIT_MS 25
+#define MAX_QUICK_PIT_MS 50
#define MAX_QUICK_PIT_ITERATIONS (MAX_QUICK_PIT_MS * PIT_TICK_RATE / 1000 / 256)
static unsigned long quick_pit_calibrate(void)
*
* As a result, we can depend on there not being
* any odd delays anywhere, and the TSC reads are
- * reliable (within the error). We also adjust the
- * delta to the middle of the error bars, just
- * because it looks nicer.
+ * reliable (within the error).
*
* kHz = ticks / time-in-seconds / 1000;
* kHz = (t2 - t1) / (I * 256 / PIT_TICK_RATE) / 1000
* kHz = ((t2 - t1) * PIT_TICK_RATE) / (I * 256 * 1000)
*/
- delta += (long)(d2 - d1)/2;
delta *= PIT_TICK_RATE;
do_div(delta, i*256*1000);
printk("Fast TSC calibration using PIT\n");
* the delta to the previous read. We keep track of the min
* and max values of that delta. The delta is mostly defined
* by the IO time of the PIT access, so we can detect when a
- * SMI/SMM disturbance happend between the two reads. If the
+ * SMI/SMM disturbance happened between the two reads. If the
* maximum time is significantly larger than the minimum time,
* then we discard the result and have another try.
*
if (cpu_khz) {
*scale = (NSEC_PER_MSEC << CYC2NS_SCALE_FACTOR)/cpu_khz;
- *offset = ns_now - (tsc_now * *scale >> CYC2NS_SCALE_FACTOR);
+ *offset = ns_now - mult_frac(tsc_now, *scale,
+ (1UL << CYC2NS_SCALE_FACTOR));
}
sched_clock_idle_wakeup_event(0);
local_irq_save(flags);
- __get_cpu_var(cyc2ns_offset) = 0;
+ __this_cpu_write(cyc2ns_offset, 0);
offset = cyc2ns_suspend - sched_clock();
for_each_possible_cpu(cpu)
ret : clocksource_tsc.cycle_last;
}
-#ifdef CONFIG_X86_64
-static cycle_t __vsyscall_fn vread_tsc(void)
-{
- cycle_t ret;
-
- /*
- * Surround the RDTSC by barriers, to make sure it's not
- * speculated to outside the seqlock critical section and
- * does not cause time warps:
- */
- rdtsc_barrier();
- ret = (cycle_t)vget_cycles();
- rdtsc_barrier();
-
- return ret >= __vsyscall_gtod_data.clock.cycle_last ?
- ret : __vsyscall_gtod_data.clock.cycle_last;
-}
-#endif
-
static void resume_tsc(struct clocksource *cs)
{
clocksource_tsc.cycle_last = 0;
.flags = CLOCK_SOURCE_IS_CONTINUOUS |
CLOCK_SOURCE_MUST_VERIFY,
#ifdef CONFIG_X86_64
- .vread = vread_tsc,
+ .archdata = { .vclock_mode = VCLOCK_TSC },
#endif
};
EXPORT_SYMBOL_GPL(mark_tsc_unstable);
-static int __init dmi_mark_tsc_unstable(const struct dmi_system_id *d)
-{
- printk(KERN_NOTICE "%s detected: marking TSC unstable.\n",
- d->ident);
- tsc_unstable = 1;
- return 0;
-}
-
-/* List of systems that have known TSC problems */
-static struct dmi_system_id __initdata bad_tsc_dmi_table[] = {
- {
- .callback = dmi_mark_tsc_unstable,
- .ident = "IBM Thinkpad 380XD",
- .matches = {
- DMI_MATCH(DMI_BOARD_VENDOR, "IBM"),
- DMI_MATCH(DMI_BOARD_NAME, "2635FA0"),
- },
- },
- {}
-};
-
static void __init check_system_tsc_reliable(void)
{
#ifdef CONFIG_MGEODE_LX
* timer based, instead of loop based, we don't block the boot
* process while this longer calibration is done.
*
- * If there are any calibration anomolies (too many SMIs, etc),
+ * If there are any calibration anomalies (too many SMIs, etc),
* or the refined calibration is off by 1% of the fast early
* calibration, we throw out the new calibration and use the
* early calibration.
clocksource_tsc.rating = 0;
clocksource_tsc.flags &= ~CLOCK_SOURCE_IS_CONTINUOUS;
}
+
+ /*
+ * Trust the results of the earlier calibration on systems
+ * exporting a reliable TSC.
+ */
+ if (boot_cpu_has(X86_FEATURE_TSC_RELIABLE)) {
+ clocksource_register_khz(&clocksource_tsc, tsc_khz);
+ return 0;
+ }
+
schedule_delayed_work(&tsc_irqwork, 0);
return 0;
}
lpj_fine = lpj;
use_tsc_delay();
- /* Check and install the TSC clocksource */
- dmi_check_system(bad_tsc_dmi_table);
if (unsynchronized_tsc())
mark_tsc_unstable("TSCs unsynchronized");