}
#endif
-/*********************** Miscelaneous Support Functions ***********************/
+/*********************** Miscellaneous Support Functions ***********************/
/*
* Determine whether the sequencer reported a residual
* for this SCB/transaction.
* that requires host assistance for completion.
* While handling the message phase(s), we will be
* notified by the sequencer after each byte is
- * transfered so we can track bus phase changes.
+ * transferred so we can track bus phase changes.
*
* If this is the first time we've seen a HOST_MSG_LOOP
* interrupt, initialize the state of the host message
scbptr, ahc_inb(ahc, ARG_1),
ahc->scb_data->hscbs[scbptr].tag);
ahc_dump_card_state(ahc);
- panic("for saftey");
+ panic("for safety");
break;
}
case OUT_OF_RANGE:
/*
* Although the driver does not care about the
* 'Selection in Progress' status bit, the busy
- * LED does. SELINGO is only cleared by a successfull
+ * LED does. SELINGO is only cleared by a successful
* selection, so we must manually clear it to insure
* the LED turns off just incase no future successful
* selections occur (e.g. no devices on the bus).
if (lastphase != P_BUSFREE) {
/*
* Renegotiate with this device at the
- * next oportunity just in case this busfree
+ * next opportunity just in case this busfree
* is due to a negotiation mismatch with the
* device.
*/
/*
* Update the bitmask of targets for which the controller should
- * negotiate with at the next convenient oportunity. This currently
+ * negotiate with at the next convenient opportunity. This currently
* means the next time we send the initial identify messages for
* a new transaction.
*/
/*
* Requeue all tagged commands for this target
- * currently in our posession so they can be
+ * currently in our possession so they can be
* converted to untagged commands.
*/
ahc_search_qinfifo(ahc, SCB_GET_TARGET(ahc, scb),
/*
* Reset the controller and record some information about it
* that is only available just after a reset. If "reinit" is
- * non-zero, this reset occured after initial configuration
+ * non-zero, this reset occurred after initial configuration
* and the caller requests that the chip be fully reinitialized
* to a runable state. Chip interrupts are *not* enabled after
* a reinitialization. The caller must enable interrupts via
ahc->next_queued_scb = ahc_get_scb(ahc);
/*
- * Note that we were successfull
+ * Note that we were successful
*/
return (0);